Left Japan. Finally settled in here in Utah. I am stationed at Hill AFB, UT now. Bought a house with a 3-car garage which I am enjoying. I have 2.5 years left in the service before I retire at 30 years. Now that I am back in the states, I have time to visit all my favorite sites again.
Finally got all the goodies installed on the cobra.
Here are the goodies:
2.9 Whipple Supercharger (Polished)
Lethal Performance 1000HP Fuel System--3 Fuel Hats/fuel lines, Zone 5, electronics, etc.
Semens Deka 80 LB High Impedance Injectors
Fore Precision Works Polished Fuel Rails
AFCO Pro Series Dual Pass Heat Exchanger
SCT Xcal3 Programmer/Handheld Tuner
PFAB Radiator Expansion Tank (Polished by Mirror Finish Polishing)
PFAB Supercharger Tank (Polished by Mirror Finish Polishing)
EGR Delete Kit
Reische 170 Degree Thermostat
Even Flow Generation 2 Head Cooling Mod
JLT Oil Separator
JLT Carbon Fiber CAI
SCT BA-3000 MAF (Polished)
MotoBlu Idler Pulley (Polished)
Accufab Single Blade Throttle Body and Intake Plenum (Polished)
Motoblue Idler Pulley
Reichard Racing 3.5 Racing Pulley (Polished by Mirror Finish Polishing)
Polished 3.0 Pulley
NGK Spark Plugs
Mcleod RXT 26 Spline Clutch
Mcleod Lightened Steel Flywheel
D&D 26-Spline Input Shaft
Lethal Performance T-56 Throwout Bearing Retainer Sleeve
Fiore Micro-Click Firewall Adjuster & Quadrant
LDC Chicago Clutch Freeplay Correction Kit
Ford Racing Roller Pilot Bearing
Ford Racing Heavy Duty Throw Out Bearing
Bassani X Pipe without Cats
Flowmaster 40s Cat-Back Exhaust
Purchased and waiting to be installed: Stainless Steel Magnaflow Exhaust System
Maximum MotorSports Chrome Caster Camber Plates
Hans Full Length Subframe Connectors
Steeda Bump-Steer Kit
Summit Racing Driveshaft Loop
Fore Precision Works Aluminum IRS Differential Cover
Eibach Pro Lowering Springs
AeroForce Dual Guages & Wideband
Speed Hut Pillar Pod
Custom Embroidered Headrests
Pro 5.0 Shifter for Tremmec T56
F'n Fast Shift Knob
Cobra Grill Emblem
Redline Hood Shocks
Tinted Rear Taillights & Rear Side Markers
Cobra Billet Exterior Gas Lid
MGP Caliper Covers
Billet Oil and Radiator Caps
UPR Chrome Oil Dip Stick
UPR Chrome Battery Hold-Down
Fore Precision Works Hood Vents
Sequential Tail Lights
Waiting to be installed: Manaflaw Stainless Steel Catback Exhuast
Next Purchase: *American Racing 1 3/4 Longtube Headers w/their X-pipe.
Couple Shots Of The Cobra & The 92 Notch I own as well.
Here is the Dyno Sheet:
Here is the dyno video:
My tuner said I should hit near 650 HP on 91 Octane and break the 700HP barrier on race gas with the new headers and new tune.
Its nice to be back in the states so I can finally enjoy the cobra. It was in storage for 4 1/2 years while I did my time in Japan.
Take care and thanks for looking!